Pipe bender

Трубогибы, листогибы, трёх валковые машины и проч.

Модератор: Nitro

Pipe bender

Новое сообщение Jennermack » Ср май 02, 2018 3:49 pm

Hi,

Any of you guys have any experience with pipe benders? I have been looking at the JD Squared model 3, it is relatively inexpensive for the bender itself. The only thing is the dies cost as much as the bender (per die). If you want three different sizes with your new bender your looking at $1200. My friend has one of the JD Squared hydraulic benders, and says you can't get much better for the money, he swears by them. I am looking to get into this for as little as possible, I'm not looking to start up a full blown fab shop. I just want to be able to build some trick stuff for my boat, and then eventually maybe pick up some side work building trick stuff for other guys boats.
Any input on this matter would be great. I'm thinking my boat really needs some kind of leaning post/tackle storage unit once I get that stupid engine box removed.

Any help will be apprecited.

I didn't find the right solution from the Internet.

References:
http://www.aluminumalloyboats.com/viewtopic.php?t=2335
Software Promo Video

Thank you.
Аватара пользователя
Jennermack
Купил перчатки. Я - гонщик!
Купил перчатки. Я - гонщик!
 
Сообщения: 13
Зарегистрирован: Пн апр 09, 2018 10:53 am
ФИО: jenner
Место жительства: Adger
Помещение: 2
Проекты: sector 2
Чем работаешь: car
Стаж работы с металлом: iron

Вернуться в Гибочное оборудование

Кто сейчас на конференции

Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 2

cron